7-22 Keypad dialing
Incoming data call
The data call is answered automatically, and an audible tone occurs. A data
call cannot be manually answered using KPD. The Automatic Answer
feature can be disabled through keyboard dialing in asynchronous mode. No
prompts are displayed unless the display is in the data call monitor mode.
To activate the incoming data call monitor mode on the display, press P64.
Incoming data call during active voice call
The data call is answered automatically, and a distinctive tone occurs. No
call processing messages appear on the display. The Automatic Answer
feature can be disabled through keyboard dialing in asynchronous mode.
Incoming data call while making a manual data call
If a voice call comes in during call set-up from the keypad, the CPND
information is not displayed. The voice call can still be answered, but is
kept on hold for the completion of the manual data call.
Reset data parameters (P65)
Procedure 7-28 describes the steps required to reset the MCA configuration
to default settings. This procedure locks configuration settings so that no
data parameters can be changed.
Note 1: Unplugging the telephone does not reset the MCA configuration.
Note 2: The P in the following procedure represents the Program key.
Procedure 7-28
Resetting data parameters
1
2
3
Emulation selection (P66)
Procedure 7-29 describes the steps required to select the modem type that
the MCA emulates.
555-4001-114 Standard 10.02 November 1999
Press P65.
Response:
The display shows the following information:
DATA PARAMETERS RESET
Press P to save the lock setting and exit the command.
Response:
The set exits the programming mode.
You have completed this procedure.