Table of Contents
Advertisement
Assembly process No.
M-1
5. Testing door lock
Close the door and check the relationship between the operator's cab and door. If there is any fault,
repair it.
5-1.Check of condition
(1) Check the installed height of the damper rubber. (Check both sides, 2 pieces on each.)
Stick an adhesive tape to the contact face of the damper rubber and open and close the door
2 – 3 times. Then, check the contact face of the adhesive tape against the operator's cab.
Normal:
Abnormal: When the door is closed, the damper rubber does not come in contact or comes
(2) Check the relationship between the door latch and striker (on both sides).
Close the door and check the engaging condition of the latch and striker.
Precautions
Testing and adjusting operator's cab (4/10)
When the door is closed, the damper rubber comes in contact lightly.
in contact so strongly that the adhesive tape is removed.
Fig. 4
Fig. 5
Necessary tools
Name
Other remarks
77
Necessary equipment
Q'ty
Name
Q'ty
Advertisement
Table of Contents
