Advertisement
Model 8902A
Installation
Section 2
I N STALL AT1 0 N
2-1. INTRODUCTION TO THIS SECTION
This section provides the information needed to install the Measuring Receiver. Included is
information pertinent to initial inspection, power requirements, line voltage selection, power cables,
interconnection, operating environment, instrument mounting, storage and shipment. This section
also contains a procedure for setting the internal HP-IB talk and listen address switches and a
procedure for removing the pull-out cards.
2-2. INITIAL INSPECTION
To
avoid hazardoirs electrical shock, do not perform c$ectrical
iesls
when lhcre
art' signs
of'
shipping damage to any porfion
o j
the
outm enclositre (covers,
panels, mcters).
Inspect the shipping container for damage. If the shipping container or cushioning material is
damaged, it should be kept until the contents of the shipment have been checked for completeness
and the instrument has been checked mechanically and electrically. Procedures for checking
electrical performance are given in Section 4 . If the contents are incomplete, if there is mechanical
damage or defect, or if the instrument does not pass the electrical performance test, notify the nearest
Hewlett-Packard office. If the shipping container is damaged, or the cushioning material shows signs
of stress, notify the carrier as well as the Hewlett-Packard office. Keep the shipping materials for the
carrier's inspection.
2-3. PREPARATION FOR USE
Power Requirements
To avoid the possibility
o j
hazardoirs cdcvtrical Jhock, do no1 opcwilc'
lhiJ
inJlrirmcnt
at
linc volfages greatcr than 126.5 Vac wirh lint1 jkeqirtvcirs
grcwlcr
than 66 Hz. Lcakagc citrrents
at
thcw linc sdtings may cxctvd 3.5 mA.
The Measuring Receiver requires a power source (+50/0 to -10%) of 100, 120, 220, or 240 Vac, 48
to 66 Hz single phase. Option 004 also operates from 48 to 440 Hz single phase, 120 Vac,
(+5%
to
-
10%
only). Power consumption is 200 VA maximum.
2-
1
Advertisement
Chapters
