Download Print this page

HP 8902A Quick Reference Manual page 375

Measuring receiver
Hide thumbs Also See for 8902A:

Advertisement

Model 8902A
Operation
Finer Resolution for dB Measurements
Special Function 32. I enables
a
resoliition of 0.00 I dB. For audio frequency measurements, this
special fiinction enables a resolution o f 0.1
Hz
for frequencies from 100 to 250 kHz instead o f the
normally displayed resoliition o f 1 Hz. T h e selection of Special Function 32.0 o r 32.1 is maintained
through instrument power down.
32.0 Power is displayed with the normal measurement resolution of 0.01 dB.
32.1 Power is displayed with a measurement resolution of 0.001 dB.
32.2 Displays
0
if the normal measurement resolution is enabled (32.0 SPCL) and displays
1
if a finer
resolution is enabled (32.1).
Use SET REF for Relative Tuned RF Level Measurements.
T h e SET REF key should be used to make scaled measurements in the Tuned R F Level Measurement
mode. (Refer to Attcnuafor Mcwsirrc.mcnts on page 3-1 15).
Modulation Flatness.
When used in conjunction with track mode tuning, the Rat.io function makes checking modulation
flatness with respect to R F freqirency very convenient. (Refer
to
Rf-'
k'rt>qucwc'y Tuning on page 3-141
for a discussion of track mode tuning.)
Setting Measurement Limits.
T h e ratio reference can also be entered as a limit reference. (Refer t o Limd o n page 3-249.)
Common Ratio Measurements.
The following list provides some usefiil references for common ratio measurements:
0
To display broadcast FM deviation relative
to
the common standard
of
75
kHz,
use
0
l o display
QM
in degrees, enter a value of 1.745 and select linear units.
0
To display AM as d B down from the carrier, enter a value of 200 and select
0
To
display rms calibrated average as true average, enter a value of 1 11.07 and select
0
To display rms calibrated average as peak, enter a value
of
70.7 and select linear
75 and linear units.
logarithmic units.
linear units.
units.
This special function is not availdblc with firmware datc codcs 234.1 985 and below.
(To display the firrnwarc dalc code. sclect
41.0 SPCL.) To
ordcr
a
ROM sct that contains
this spccial function. contact the ncarcst HP salcs officc.
3-248

Advertisement

loading