Advertisement
1-2
The Setup
Diagram
1-1.
Setup for Learning Basic Operation
To get ready to learn to use the HP 8902A, connect the HP 8902A, an
HP
11 722A Sensor Module, and a signal generator together as shown
in Diagram 1-1.
The HP 8902A
If you are unpacking a new HP 8902A you will want to refer to the
installation suggestions provided in Appendix A .
The HP 7 7 722A
The procedures in this guide are written for use with an HP 11 722A
Sensor Module. There are many power sensors that can be used
with the HP 8902A as well. If you are using a power sensor
(rather than a Sensor Module), refer to your HP 8902A Operation
and Calibration Manual for information on which power sensors
can be used and how to operate them with the HP 8902A.
The Calibration Data
Once the HP 8902A is up and running, you will need to first determine
if the calibration data for the Sensor Module you are using has been
stored in the HP 8902A. Appendix B contains a procedure for determining
whether the correct calibration data has been entered into the HI' 8902A.
(Refer t o Appendix B
if
you are not certain that the calibration data for
the Sensor Module you are using has been entered into the HP 8902A.)
Advertisement
Chapters
