Advertisement
Model 8902A
General Information
Section 1
GENERAL INFORMATION
1-1. INTRODUCTION TO THIS MANUAL
The H P 8902A Operating and Service Manual is comprised of an Operation and Calibration Manual
and the three volume Service Manual. These four volumes contain all the information required to
install, operate, test, adjust, and service the Hewlett-Packard Model 8902A Measuring Receiver.
The information to operate and service this instrument is made available as follows: Sections
1
through
5 are contained in the Operation and Calibration Manual (that includes the Basic Operation and
Application Guide) which is provided with each instrument. Sections 6 through 8 are contained in the
Service Manual that is not included with the instrument but which can be obtained by mailing in the
Service Manual Request Card included in this manual.
The Measuring Receiver is shown in Figure 1-1 with all supplied accessories. These manuals document
Measuring Receivers supplied with Options 001,002,003,004, series 030 and 050.
Operation and Calibration Manual
Section 1, General Information describes the instruments documented by this manual and covers
instrument description, options, accessories, specifications and other basic information. This section
also contains instrument theory of operation on a simplified block diagram level.
Section 2, Installation provides information about initial inspection, preparation for use (including
address selection for remote operation), and storage and shipment.
Section 3, Operation provides information about panel features and includes operating checks, and
operating instructions for both local and remote operation.
Section 4, Performance Tests provides the information required
to check performance of the
instrument against the critical specifications in Table 1-1.
Section 5, Adjustments provides the information required
to properly adjust the instrument.
Service Manual
Section 6, Replaceable Parts provides ordering information for
a l l
replaceable parts and assemblies.
Section 7, Instrument Changes provides backdating information, and retrofitting and modification
information.
Section 8, Service provides the information required
to
repair the instrument.
Additional copies of the Operation and Calibration Manual or the Service Manual can be ordered
separately through your nearest Hewlett-Packard office. The part numbers are listed on the title page
of this manual.
rev.24AUG87
1-1
Advertisement
Chapters
