Wireguard Client Settings Tab - Hirschmann NetModule AP3400 User Manual

Client uses a wireguard server to establish and maintain the secure connection.
– Port - specify the port on which the wireguard connection will work (default 51820).
– IP address - specify the wireguard IP address of the client. Client wireguard IP addresses must
be on the same network as the server wireguard IP.
– Netmask - specify the netmask that determines the size of the wireguard network.
– Public and private key - click the generate button next to the private key field to generate both
private and public keys.
– Private key - should be kept secret, it is used by the wireguard to generate a public key.
– Public key - you will need to enter this public key in the wireguard server configuration. This
key allows the wireguard to encrypt and decrypt information on the client-server connection.
Click a "generate" button next to the private key field to generate both keys.
– Server address - enter the public IP address of the server (this public IP address is not the same
as wireguard IP address; public IP address is the actual IP address by which server is reachable
by client).
– Server port - enter the same port as is configured on the server side (default 51820).
– Public key - specify the server public key, which is generated on the server side.
– Persistent keepalive - when enabled, a keepalive packet is sent to the server with a specified
interval in seconds. Setting it to 0 turns the feature off (default).
AP3400
Figure 5.22.: Wireguard client settings tab
36 User Manual for version 1.9.1