Installation Of The Local Area Network; Installation Of The Power Supply; Rest Api - Hirschmann NetModule AP3400 User Manual

Table of Contents

4.2. Installation of the Local Area Network

Up to two 100/1000/2500 Mbps Ethernet devices can be directly connected to the wireless access

point, further devices can be attached via an additional Ethernet switch. Please ensure that the con-

nector has been plugged in properly to

otherwise experience sporadical link loss during operation. By default, the wireless access point is

conﬁgured as a DHCP client, with fallback adress 192.168.1.200

Attention:

Only a shielded Ethernet cable may be used.

The wireless access point can be powered with an PoE or PoE+ supply. It works with active and

passive PoE. If passive PoE is used 48 V

getting engaged.

Attention: Only CE-compliant PoE power supply may be used with the NetModule

wireless access point

The AP3400 is conﬁgured with REST API from a NetModule router. Refer to the corresponding router

manual for information about how to conﬁgure.

The REST API is documented with Swagger and the corresponding JSON schema which can be found

in https://share.netmodule.com/public/system-software/.

Alternatively the AP3400 can be conﬁgured with the WebGUI. See next chapters.

Note: Either REST API or GUI may be used, not both together.

AP3400

respectively

and remains in a ﬁxed state, you might

is necessary. The wireless access point is now ready for

User Manual for version 1.9.1

Table of Contents