Table of Contents
Advertisement
WEB GUI. The "DHCP active leases" table shows IP addresses assigned to all currently connected
devices as well as their unique MAC addresses.
Ethernet Configuration
Figure 5.18.: Ethernet settings tab
The Ethernet configuration page lets you assign ethernet interfaces to specific LAN or WAN networks.
By default there is one WAN network created on the AP3400 board, and one LAN network. The WAN
network has an "Internet" name and Ethernet 0 and Ethernet 1 Interface added to it. The LAN network
has "Local Network" name and no interfaces added to it.
Auto-negotiation - when switched on (default), the board will automatically recognize ethernet line
speed and duplex mode.
Fixed speed - parameter is available when auto-negotiation is off. Allows you to select the preferred
line speed and duplex mode.
Static routes
Static routing is a form of manual configuration of routing entries, telling each IP network what is the
next hop that the traffic should be delivered to.
Figure 5.19.: Static route settings tab
Route Name - Give a name for a route for readability.
Network and Subnet Mask - A range of IP addresses that will be routed .
Gateway - Next hop for which the range of IP addresses will take.
AP3400
33
User Manual for version 1.9.1
Advertisement
Table of Contents
