Complete Startup - ABB NGC8200 User Manual

Figure 6-34: Process stream analysis running
2. Click Next.
6.5.9

Complete startup

The device should continue to cycle through all enabled streams, performing analysis and producing
data. If it was determined that calibration is required, it is recommended that the device be allowed to
run for at least eight hours before calibration to allow the device to stabilize.
To complete the Startup Wizard:
1. On the Complete tab, click Close to exit the wizard
Figure 6-35: Final Wizard screen
After the wizard is closed, the Operation screen displays
or operation of the analyzer click Show Tree View.
6 8 | N G C8 20 0 A N D PG C 10 0 0 US ER MA N UA L | 21 01 51 0MN A H
(Figure 6-35).
(Figure 6-36). For additional configuration