ABB NGC8200 User Manual page 82

Figure 8-4: Analyzer Communication Ports tab
4. Select the Network tab
5. Ensure DHCP is set to No.
6. Configure IP parameters: Type IP address, default gateway, subnet mask. Take note of the IP
address. It will be needed later to verify network communication.
7. Set the Network Adapter to Enable.
Figure 8-5: Configuration for Network connection
8. Click Send. The new IP parameters display.
8 2 | N G C8 20 0 A N D PG C 10 0 0 US ER MA N UA L | 21 01 51 0MN A H
(Figure 8-5).