Table of Contents
Advertisement
BT5300 Series
User Manual
The default input impedance is 10 MΩ. It is recommended to use High-Z (>10GΩ)
option for high impedance device under test, such as enclosure potential
measurement.
3. Press D (OK) to confirm the selection and return to the Instrument Setup screen.
Press E (Cancel), to return to the Instrument Setup screen and not save any change.
Remote Interface
The Product provides RS-232 interface and an Ethernet interface on the rear panel, users can use
these interface through a PC to change settings, obtain readings, and control the Instrument.
Command syntax and names follow the IEEE-488.2 and SCPI standards. See the section
Control
for details.
To ensure normal communication, the communication port of the Product needs to be set up
correctly.
To set remote Interface:
In the Instrument Setup screen, use the up and down arrow (M N) buttons on the front panel to
move the cursor to the Remote Interface option (the option is highlighted in yellow).
The Remote Interface screen is as shown in
interface are shown in
58
Figure 34. Selecting input impedance
Table
13.
Note
Figure
35. The options for RS-232 and Ethernet
Remote
Advertisement
Table of Contents
