Fluke BT5300 Series User Manual page 86

BT5300 Series
User Manual
Bit No.
Bit 11 Measure Done
Bit 12 Ready for Initiate Trigger
Bit 13 NOT USED
Bit 14 NOT USED
Bit 15 Always 0
Bit No.
Bit 0 Operation Complete
Bit 1 Request Control
Bit 2 Query Error
Bit 3 Device Dependent Error
Bit 4 Execution Error
Bit 5 Command Error
Bit 6 User Request
Bit 7 Power On
Note: * See List of Error
Bit No.
Bit 0 NOT USED
Bit 1 NOT USED
Bit 2 Error/Event Queue
Bit 3 Questionable Status
Bit 4 MAV
Bit 5 Standard Event Status
Bit 6 RQS
Bit 7 Operation Status
74
Bit Name
One measurement is done.
Ready for Initiate Trigger (*TRG or Trigger key) when INIT:CONT
OFF and TRIG:SOUR EXT.
Not used
Not used
The use of Bit 15 is not allowed since some controllers may have
difficulty reading a 16 bit unsigned integer.
Table 19. Standard Event Status registor
Bit Name
Set when error code* is between -800 and -899.
Set when error code* is between -700 and -799.
Set when error code* is between -400 and -499.
Set when error code* is between -300 and -399.
Set when error code* is between -200 and -299. For example,
range error.
Set when error code* is between -100 and -199. For example,
syntax error.
Set when error code* is between -600 and -699.
Set when error code* is between -500 and -599.
Message.
Table 20.
Bit Name
Not used
Not used
Error/Event queue message available.
Operation Status flag.
Output queue message available.
Standard Event Status flag.
Service request. The summary based on the logical sum of all
other bits of the Service Request Enable Register and Status Byte
Register.
Operation Status flag.
Description
Description
Status Byte registor
Description