Selecting A Test Pattern; Adjusting The Lens; Osd Lens Menu - Digital Projection E-Vision Laser 15000 Series Instruction Manual

Basic Operating Instructions

Selecting a test pattern

The following test patterns are available: White, Black, Red, Green, Blue, Checkerboard, White
Crosshatch, Red Crosshatch, Green Crosshatch, Blue Crosshatch, Color Bar, Screen Layout,
Off
To display a test pattern:
Press TEST on the remote control.
l
Change the test pattern using the LEFT and RIGHT arrow buttons.
Alternatively, open the OSD by pressing MENU. Highlight Test Patterns from the main
l
menu, then select a test pattern using the LEFT and RIGHT arrow buttons.
After the final test pattern, the projector exits test pattern mode and returns to the main image.
To view test patterns again, you need to press TEST again. If you wish to exit the test patterns
before you reach the final one, press TEST or EXIT at any time.

Adjusting the lens

You can use the following options to adjust the lens:
Control panel. See Control panel on page 33
l
Remote control. See Remote control on page 35
l
On screen display (OSD). See Lens menu on page 1
l

OSD Lens menu

The Lens menu provides access to the Lens Control setting and the Lens Center command.
Lens Control allows Zoom, Focus and Shift adjustments using the arrow buttons. The setting
operates in Zoom/Focus Adjustment and Shift Adjustment mode.
Press ENTER/SELECT to switch between the two modes.
Important Information
Digital Projection E-Vision Laser 15000 Series
Rev B April 2021
page 31