Door Strike - Haier GE GDF510P M0 Series Technical Service Manual

GDF640H GDP615H GDT605P, GDT610H and
1. Remove power, then remove and separate
the door.
2. The inner panel may be set into the
dishwasher and latched in the closed position.
3. Reapply power.
4. Place the dishwasher into Service Mode
(see Service Mode under the Electronic
Controls section in this service guide), then
activate the detergent test to check for 13.5
VDC to the detergent module. Service Mode
will provide a 15 second activation time.
1. Remove power to the dishwasher.
2. Remove and separate the door.
3. Remove the EPS cover, double back tape
is used to secure and is reusable (when
reinstalling the EPS cover, UP must be
toward the top of the door).
4. Remove six 1/4-inch hex-head screws.
5. Mounting plate removes from inside the door.
6. The detergent module can now be removed
from the inner door panel.

Door Strike

The Door Strike is attached to the inner door
panel.
Door Strike Removal
1. Remove and separate the door.
2. Remove the control console or control panel.
3. Remove the pocket handle (on front control
models only).
– 37 –
Mounting Plate
(Continued next page)