Check Door Spring Tension; Move Dishwasher Into Cabinet Opening - Haier HDBC100AFS Installation Instructions Manual

8. Extend leveling legs out from the dishwasher base, 1/4" less than opening height.

CHECK DOOR SPRING TENSION

With another person holding the dishwasher to prevent it from tipping, open and
close the door a few times. If the door closes too quickly or falls open under its own
weight, the door tension will need to be adjusted.
•
If the door closes too quickly, decrease the spring tension by pulling the spring
adjustment pin out of its hole and reinsert it in the next lower hole toward the
bottom of the dishwasher.
•
If the door falls open, increase the spring tension by pulling the spring
adjustment pin out of its hole and reinserting it in the next higher hole toward
the top of the dishwasher.
•
Spring adjustment pins should be in the same holes on both the left and right
sides.

MOVE DISHWASHER INTO CABINET OPENING

Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
1. Using two or more people, stand the dishwasher up.
2. Grasp the sides of the dishwasher at the edges of the door panel.
leveling leg
WARNING
Excessive Weight Hazard
17