Racks - Haier GE GDF510P M0 Series Technical Service Manual

Diagnoses can be accomplished in Consumer
Error Mode (see Consumer Error Mode under
the Electronic Controls section of this service
guide) or with an ohm meter at the main control
board as described below.
1. Access the main board.
2. Locate and disconnect connector J711.
3. Check continuity from pin 3 (tan and red) to
pin 4 (violet and yellow) and pin 3 (tan and
red) to pin 5 (white and silver). Both should
be open when the door is open and closed
when the door is closed.

Racks

Upper Rack
on the model: adjustable and non-adjustable.
Both are similar in design of rails and rollers.
Non-Adjustable Upper Rack
To remove the rack from the dishwasher, pull the
rail assembly out a few inches for easier access.
Press the tab on the end cap to the center of the
dishwasher and pull the end cap off the rail.
The rack may now be removed.
Upper Rack Rollers and Brackets
The upper rack roller brackets are locked into
place with a clip. The clip must be removed to
remove the roller brackets from the rack. Press in
on the tab and lift the locking clip.
The tub rollers are attached to the tub with a
screw in each roller.
– 23 –