Tub And Structure; Tub Trim (Some Models); Toe Kick; Junction Box And House Wiring Connection - Haier GE GDF510P M0 Series Technical Service Manual

The Tub and Structure section of this guide
will cover the toe kick, junction box, racks,
leveling legs, door balance, gaskets, trim (on
some models), main control board, door, door
components, as well as the removing and
separation of the screwless appearance door. It
will also cover the sump module and removal.
Details of the sump components will be covered
in the Circulation System or Drain System
sections of this service guide.
Some models include tub trim which clips to the
plastic tub to reduce sound levels and provides a
cleaner appearance to the installation.
Tub Trim
If the cutout prevents the dishwasher from being
fully installed, or if the trim rolls inward preventing
the door from closing, it may be trimmed to
cabinet to be an effective sound barrier.
WARNING: GE Factory Service Technicians

Tub and Structure

Toe Kick

The toe kick is a decorative panel covering the
machine area of the dishwasher. The panel
provides a safety barrier, closing the front of the
dishwasher machine compartment. The toe kick
prevents injury from electrical components under
the dishwasher. To remove the panel, remove
two 1/4-inch hex-head screws and pull the panel
away from the dishwasher.
Insulation
Block
Connection
The Junction Box is located behind the toe kick
on the right-hand side of the dishwasher. The
junction box is where the 120 VAC house
voltage connects to the dishwasher. The
dishwasher may be hardwired or an optional
cord may be installed (available separately, Part
#: WX09X70910), which plugs into a wall outlet
and connects to the harness plug into the control
(see the separate Installation Guide for more
information). The cover is held in place with a
1/4-inch hex-head screw on the left side, and tab
on the right side. To remove the cover, remove
the screw and pull out and left to release the tab.
– 19 –
Toe Kick
Screws
Toe Kick