Door Gasket; Vent Parts (Except Gdp615); Detergent Dispenser - Haier GE GDF510P M0 Series Technical Service Manual

Door Gasket

1. Remove the door.
2. Place the door on a protected surface to
prevent damage.
3. On plastic inner door models, slide the gasket
either direction to remove. The door does not
need to be separated on plastic inner doors.
End View
4. On SS Inner Door models, the inner door
panel has the door gasket riveted to the panel.
The inner door panel must be replaced to
replace the door gasket.
Front Control Models
Console Insulation
Gasket
Vent
Gasket
Conduit
Top Control Models
Insulation
Gasket
Handle
Bracket
and Grill
Vent
Conduit
Insulation
Front Panel
Gasket
The detergent module is Solenoid operated, using
13.5 VDC to activate the solenoid.
The GDF510PxJxx and GDT535PxJxx send 13.5
VDC from the main control under the Dishwasher.
All other models send the 13.5 VDC from the UI
board in the door.
Some models have a rinse agent dispenser.
The dispenser holds 3.5 oz. (100 ml) of rinse
agent. Under normal conditions, this will last
approximately one month.
The module receives 13.5 VDC for .5 seconds to
activate the detergent cup. To activate the rinse
aid the module receives 13.5 VDC for a period of
15 seconds.
Remove power to dishwasher.
Remove toe kick panel.
Disconnect door harness.
The resistance for the detergent module
checked at the module or the door harness as
it enters the bottom of the main control board.
Connector J401 pins 2 AX (aqua) to 4 CW
(brown/white). Board connector and pin out
is found in the Electronic Controls section of
this service guide. Voltage may be checked
during service mode.
– 36 –