Top Control Console Cover - Haier GE GDF510P M0 Series Technical Service Manual

5. The light pipe separates from the bottom
cover with tabs. A small screwdriver may be
6.
release the remaining tabs (four each side).
7. With the light pipe removed, the UI may be
lifted out of the bottom cover.
When replacing UI control boards, the new UI
included with the replacement. If the
personality is not set by using the 4 jumpers,
properly.
are found in the Electronic Control section
of this service guide.

Top Control Console Cover

Top Control Console Cover Removal
1. Remove and separate the door.
2. Remove the bottom cover, UI, light pipe and
buttons.
3. Remove the top console and cover as an
assembly. There are six 1/4-inch hex-head
screws, securing the assembly to the inner
door (note the length of the screws). A new
cover should be replaced in the event the
cover is loose or must be removed. The tabs
are likely to break on removal.
1. The top cover is secured with sixteen tabs,
and the console has cutouts or slots to allow
the top cover to click lock together.
2. Position the tabs on the cover into the slots
on the console.
3. Press the top and console securely together
and slide the parts to engage the tabs into the
slots. Start from one end and work across to
will be heard as the cover and console snap
together.
– 34 –
Six 1/4 in. hex-
head screws