- After removing the packing, check to make sure that the appli- ance is not damaged. If in doubt, contact a qualified professional. - The dishwasher must only be used by adults for the washing of household dishes and cooking utensils.
Close-up View (Interior) A Cup Rack B Upper Rack C Rack Height Adjustor D Top Spray Arm E Lower Rack F Bottom Spray Arm Technical characteristics Width Depth Height Capacity Mains water pressure Power voltage Total absorber power G Washing Filter H Detergent and Rinse Aid Dispenser J Knife rack K Third Sprayer...
Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table". The detergent dispenser is located on the inside panel of the door.
Loading the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed.
After having completed all of the installation steps in the preced- ing paragraphs, turn on the water to the unit, partially open the door of the dishwasher, and press the ON-OFF button "A" lo- cated on the control panel. The "B" indicator light will come on.
Wash Cycle Table Cycle Cycle Selection Information Very dirty dishes, pots and pans. (Not to be used with delicate items) Intensive Normal dirty dishes, pots and pans. Standard daily cycle. Normal Wash Normal dirty dishes, pots and pans without dried on residue.
Energy Saving Tips -It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the soak cycle.
- the rinse aid dosage is correct. Error Messages The dishwasher is equipped with a safety system that is able to detect operating problems and malfunctions. These malfunctions are signalled by the rapid blinking of one of the "M" program LEDs.
Levelling the Appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the level of the dishwasher. The appliance should not be inclined more than 2˚. If it is level, it will help en- sure proper performance.
Need help?
Do you have a question about the HDW300SS and is the answer not in the manual?
Questions and answers