Carrier Access Wide Bank 28 DS3 User Manual page 350

TL1 Commands and Messages
TL1 Command List
Category:
Security:
Syntax:
Example:
9-76
Not Reported (NR) events do not produce any REPT messages. However, these
events are logged and can be retrieved by the RTRV-COND command (see RTRV-
COND-<AIDType> on
Transport Surveillance Commands
RW
SET-ATTR-{T3|T1|E1|EQPT}:[<tid>]:[<aid>]:[<ctag>]::
<ntfcncde>,<condtype>,<locn>,<dirn>,<tmpr>;
Field
aid
condtype
ctag
dirn
locn
ntfcncde
tid
tmper
SET-ATTR-T1:tid::ctag::MN,LOS,,,;
Assign Minor alarm severity to T1 Loss of Signal.
page 9-59).
Description
Access ID must be ALL or omitted
Type of alarm or event condition.
Only the following conditions are valid:
• AISNAS – Alarm Indication Signal, North American
Standard
• BER-SF – Bit error rate signal failure
• BER-SD – Bit error rate signal degrade
• CONTEQPT – Control equipment failure
• FAILTOSW – Failure to switch
• IMPROPRMVL – Improper removal
• INT – Internal hardware failure
• INTERR – Internal error detected
• LOF – Loss of frame
• LOS – Loss of signal
• PWR – Power +5V failure
• RAI – Remote Alarm Indication
• SYNCPRI – Loss of designated clock
• TRMT – Transmitter failure
Correlation Tag (optional)
Direction – not supported in this release
Location – not supported in this release
Alarm severity notification code:
• CR – Critical, *C
• MJ – Major, **
• MN – Minor, *
• NA – Not Alarmed, A
• NR – Not Reported
Target ID of network element (optional)
Time period that these statistics were gathered – not supported
in this release
July 2004 Wide Bank 28 DS3 - Release 2.4