Carrier Access Wide Bank 28 DS3 User Manual page 316

TL1 Commands and Messages
TL1 Command List
Category:
Security:
Syntax:
Example:
Example:
9-42
Note: A channel's LOS inhibit will also be disabled immediately if any of the
following events occur:
• the channel is disabled (set out of service)
• a hardware failure occurs on the channel
• a metallic loopback is run on the channel
• the channel is manually moved to a spare
• the channel's card is removed.
However, if a channel is disabled and then re-enabled while an LOS condition is
present, the automatic in-service detection will again inhibit the LOS alarm.
Automatic in-service detection is applied on a channel-by-channel basis. If service is
discontinued on a channel, automatic in-service detection can be reapplied to that
channel by placing it out of service (see RMV-<AIDType> on
in service (see ENT-<LSType> on
To quickly provision automatic in-service detection when turning up a new Wide Bank,
first turn on automatic in-service detection and then place all (aid = ALL) T1s or E1s
out of service and then back in service.
Transport Surveillance Commands
RW
OPR-ARC-<T1|E1>:<tid>:<aid>:<ctag>::QI,[<delay>];
Field Description
aid Access ID must either be ALL or be omitted. If omitted, the default is
ALL.
ctag Correlation Tag (optional)
delay
Delay time in hours, 1 to 168 (1 week). If omitted, the current value
remains unchanged. Factory default is 2 hours.
QI Qualified Inhibition (optional). If omitted, the default is QI.
tid Target ID of network element (optional)
OPR-ARC-T1:tid::ctag;
Turn on automatic in-service detection.
OPR-ARC-T1:tid::ctag::QI,12;
Turn on automatic in-service detection and set delay time to 12 hours.
page 9-33).
July 2004
page 9-46) and then back
Wide Bank 28 DS3 - Release 2.4