Carrier Access Wide Bank 28 DS3 User Manual page 232

CLI Commands and Messages
CLI Command List
Message:
Equipment
---------
DS3 Controller A
DS3 Controller B
DS1 Card 1
DS1 Card 2
DS1 Card 3
DS1 Card 4
DS1 Card 5
DS1 Card 6
DS1 Card 7
DS1 Spare Card
Equipment
DS3 Controller A/B
DS1/E1 Card
8-44
Status
------
Active
Card not present
Active
Active
Active
Active
Active
Active
Active
Active
Status Description
Active Controller card is installed and in active mode (DS3 circuit is active)
Standby Controller is installed and in standby mode
Not Present Controller is not installed
Not Ready Controller is present but is not communicating with the active card
for unknown reasons
Fail Controller hardware failure
Active DS1/E1 card is installed and active but individual DS1/E1 circuits
may have failed and be on Spare card
Not Present DS1/E1 card is not installed
MSO Active DS1/E1 MSO card (relay and electronics) is installed and active but
individual DS1/E1 circuits may have failed and be on Spare card
MSO Relay Only DS1/E1 MSO relay card is installed but electronics card is missing.
Active on Spare Circuits have been switched to Spare card.
MSO Relay Only DS1/E1 MSO relay card is installed but electronics card is missing.
Not Active Circuits have been switched to Spare card.
MSO Relay Only DS1/E1 MSO relay card is installed but electronics card is missing.
Conflict On Spare Multiple MSO card removals prevent switching circuits to Spare.
MSO Relay Only DS1/E1 MSO relay card is installed but electronics card is missing.
Spare Not Present Circuits cannot be switched because Spare card is not installed.
Wrong Card for System mode is set to DS1 when E1 card is installed, or vice versa.
Mode Status applies to both MSO and non-MSO card types.
July 2004 Wide Bank 28 DS3 - Release 2.4