Carrier Access Wide Bank 28 DS3 User Manual page 248

CLI Commands and Messages
CLI Command List
Syntax:
Example:
- LS Circuit 5
Performance Thresholds:
coding violations - line:
errored seconds - line:
Example:
8-60
ls {number|range|list} pm threshold [interval error value]
Field Description
ls pm threshold Use the command by itself to show the current setting
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
interval Specify measurement time interval (see Interval table below)
error Specify error type (see Error table below)
value An integer value specifying the threshold error count for the
measurement interval.
Set to zero to disable threshold crossing alerts.
Interval Description
15 minutes
min15
One hour
hour
day One day
Error Description
cvl Code Violations - Line. The total number of line code violations that
have been detected during the measurement interval. A CVL is the
occurrence of a Bipolar Violation (BPV).
Errored Seconds - Line. The number of one-second intervals
esl
containing one or more CVLs or one or more Loss of Signal (LOS)
defects.
ls 5 pm threshold
The following message shows the default values defined in GR-820-CORE.
ds1 1-4 pm threshold min15 cvl 32
Set DS1 circuits 1 to 4 for PM threshold CVLs to 32 for each 15-minute report interval.
15 min.
-------- --------
13340
65
July 2004
1 hour 1 day
--------
40020 133400
195 648
Wide Bank 28 DS3 - Release 2.4