Carrier Access Wide Bank 28 DS3 User Manual page 324

TL1 Commands and Messages
TL1 Command List
9-50
Field Description
LINECDE Indicates DS1 line code.
E1 is always HDB3 (high density bipolar 3).
Valid DS1 values are:
• AMI (Alternate mark inversion)
• B8ZS (Bipolar with 8-zero substitution)
OMODE Specifies what will be transmitted from the DS1 output port. The
Wide Bank supports:
• NORM (Normal)
• AIS (Alarm Indication Signal)
RVRTFLAG Indicates the DS1 is locked onto the spare due to repeated
unsuccessful attempts at reverting to the working card. The DS1 will
remain on the spare until this flag is cleared, the DS1 card is replaced,
or the DS1 is manually moved home.
state block The block following the last colon in the RTRV-T1 command
response is the state block. This block contains the primary state
(PST and SST)
(PST) parameter that indicates the primary state and qualifier
information of the entity as defined in GR-1093-CORE and
sometimes contains the optional secondary state (SST) parameter
which indicates the secondary state information.
Values for the PST and their meanings are:
• IS-EQ – in service (enabled) and equipped
• IS-RLY – in service with relay card only (XCVR removed)
• IS-UEQ – in service and unequipped
• OOS-EQ – out of service (disabled) and equipped
• OOS-RLY – out of service with relay card only (XCVR is
removed)
• OOS-UEQ – out of service and unequipped
Values for the SST and their meanings are:
• NALMNR – The auto in-service feature is on and an LOS alarm is
being suppressed on this DS1.
• NALMCD – The auto in-service feature is on, a good signal exists,
but it has not persisted for 2 minutes yet.
July 2004 Wide Bank 28 DS3 - Release 2.4