Carrier Access Wide Bank 28 DS3 User Manual page 144

Configuration
Downloading New Software
NOTE:
have to do it later, using a program flash command. Until you program FLASH your Wide
Bank is still running the old firmware.
Do you want to Program the FLASH now (Y/N)?
3. Enter Y.
NOTE:
appears. It warns that an interruption of traffic (up to 90 seconds) will occur.
WARNING: Secondary Controller is not present
Programming the FLASH will cause interruption of traffic.
Do you want to Program the FLASH now (Y/N) ?
4. Enter Y.
Please wait until this controller comes alive (Approximately 1
min.)
Firmware upgrade in process...
Erasing Flash. Please wait...
Programming Flash. Please wait...
Programming Successful.
The system now resets, during which the DS3 traffic is interrupted for up to 90 seconds.
NOTE:
the Telnet session after the reset.
6-36
A prompt asks if you want to program the FLASH now. If you say no, you will
Because there is no secondary (backup) Controller, the following message
If you are using a Telnet session for this download, you will have to re-establish
July 2004 Wide Bank 28 DS3 - Release 2.4