Carrier Access Wide Bank 28 DS3 User Manual page 272

CLI Commands and Messages
CLI Command List
Example:
8-84
Field Description
password Set or change a user's password. After entering this command, the
user is prompted to enter a new password and to confirm it (see
example).
Basic security – With basic security, passwords can be from 1 to 10
alphanumeric characters and are case-sensitive. Spaces and special
characters are not allowed. Up to 32 characters may be entered but
only the first 10 will be used. If the password is left blank, no
password is required. After successfully logging in, any user can use
this command to change their own password.
Security Upgrade – With the Security Upgrade, only the secu user
can set or change passwords. Passwords must be from 8 to 10
characters and are case-sensitive. Passwords must contain at least one
each of the following types of characters: upper-case alphabetic,
lower-case alphabetic, numeric, and special characters. The
acceptable characters are listed in the following table.
Characters Acceptable Values for Security Upgrade Password
(Must Contain at Least One Character From Each Group)
A - Z
Alphabetic
Uppercase
a - z
Alphabetic
Lowercase
Numeric 0 - 9
Special
!
Characters
?
user
User Level
---- -----
security secu
john admin
bill rw
marie rw
jack ro
morgan ro
Example is from a Wide Bank with the Security Upgrade option.
'
$ % & ( )
@ [ \ ] ^
Last Login
----------
11:39:36 06/23/2004 (Active)
11:39:36 06/23/2004
11:02:52 06/23/2004
Never logged in
Never logged in
11:39:14 06/23/2004
July 2004
* + - . /
_ ' { | } ~
Wide Bank 28 DS3 - Release 2.4
< = >