Carrier Access Wide Bank 28 DS3 User Manual page 219

Wide Bank 28 DS3 - Release 2.4
Field Description
number Low-speed interface number, 1 to 28
range A range of low-speed channels separated by a hyphen as in 5-8
list A list of low-speed channels separated by commas as in 1,3,5,9
all All low-speed interfaces
send Send a code pattern (see settings below)
Setting
off
ais
cbit loopdown
cbit loopup
csu loopdown drop
csu loopdown network
csu loopup drop
csu loopup network
niu loopdown drop
niu loopdown netowrk
niu loopup drop
niu loopup network
prbs drop
prbs network
prbs test drop
Description
Send no code or stop sending code
Send alarm indication signal (AIS) toward the low-speed side
Send C-bit loopdown request toward the far-end low-speed
circuits on the DS3 network side using DS3 C-bit FEAC code
words. DS3 C-bit parity framing mode only
Send C-bit loopup request toward the far-end low-speed circuits
on the DS3 network side using DS3 C-bit FEAC code words.
DS3 C-bit parity framing mode only.
Send CSU loopdown code (100) toward the low-speed side and
wait for acknowledge
Send a CSU loopdown code (100) over DS3 toward the far-end
low-speed circuit
Send CSU loopup code (10000) toward the low-speed side and
wait for acknowledge
Send CSU loopup code (10000) over DS3 toward the far-end
low-speed circuit
Send NIU loopdown code request toward DS1 drop side
Send NIU loopdown code request over DS3 toward DS1 NIU at
remote end
Send NIU loopup code request toward DS1 drop side
Send NIU loopup code request over DS3 toward DS1 NIU at
remote end
Send unframed PRBS code toward the low-speed side. The
manager monitors the low-speed receive to detect PRBS errors
and will display the error count, error rate, and synchronization
state (sync/no sync).
Send unframed PRBS code toward the network side.
Perform Automated PRBS Test of DS1 drop side. The Wide
Bank will send an unframed PRBS code for 10 seconds and then
display the test result.
July 2004
CLI Commands and Messages
CLI Command List
8-31