Carrier Access Wide Bank 28 DS3 User Manual page 240

CLI Commands and Messages
CLI Command List
Security:
Syntax:
Example:
Example:
8-52
Note: A channel's LOS inhibit will also be disabled immediately if any of the
following events occur:
• the channel is disabled (set out of service)
• a hardware failure occurs on the channel
• a metallic loopback is run on the channel
• the channel is manually moved to a spare
• the channel's card is removed.
However, if a channel is disabled and then re-enabled while an LOS condition is
present, the automatic in-service detection will again inhibit the LOS alarm.
Auto in-service detection is applied on a channel-by-channel basis. If service is
discontinued on a channel, automatic in-service detection can be reapplied to that
channel by placing it out of service and then back in service (see LS ENABLE/DISABLE
on page 8-53).
To quickly provision automatic in-service detection when turning up a new Wide Bank,
first turn on automatic in-service detection and then place all DS1s or E1s out of service
and then back in service.
Set - rw and above
Show - ro and above
ls ains [on|off|delay time]
Setting Description
ls auto/in service Use the command by itself to show the current setting
on Enables automatic detection of new low-speed service on channels
that are subsequently enabled, and inhibits LOS alarms until a new
service has been connected for at least 2 minutes
off Disables automatic in-service detection and allows LOS alarms on all
low-speed channels
ls ains on
Enable automatic in-service detection of all low-speed channels that are subsequently
enabled.
ls ains delay 12
Set automatic in-service delay to 12 hours.
July 2004 Wide Bank 28 DS3 - Release 2.4