Carrier Access Wide Bank 28 DS3 User Manual page 331

Wide Bank 28 DS3 - Release 2.4
Field Description
aid Access ID must be ALL or omitted
condtype Type of alarm or event condition.
Only the following conditions are valid:
• ACTLPBK – Loopback send code is Active
• AISNAS – Alarm Indication Signal, North American Standard
• BER-SF – Bit error rate signal failure
• BER-SD – Bit error rate signal degrade
• CONTEQPT – Control equipment failure
• FAILTOSW – Failure to switch
• IMPROPRMVL – Improper removal
• INHAUTORSTEQPT – Revertive Off
• INHAUTORSTSYNC – DS3 clockrevert Off
• INHLPBK – Loopdetect Off
• INHSWPR – Facility protection not enabled
• INHSWWKG – Equipment protection not enabled
• INT – Internal hardware failure
• INTERR – Internal error detected
• LOF – Loss of frame
• LOS – Loss of signal
• LPBKEQPT – Equipment loopback
• LPBKLINE – Line loopback
• LPBKMETALLIC – Metallic loopback
• LPBKPAYLOAD – Payload loopback
• NORMAL – Normal is used only for REPT EVT "clear" condition,
with clarification in the description field to indicate which
condition has cleared.
• PROTNA – Protection unit is not available
• PWR – Power +5V failure
• RAI – Remote Alarm Indication
• SYNCPRI – Loss of designated clock
• TRMT – Transmitter failure
• T-CVL – Threshold Violation - CV Line
• T-CVP-P – Threshold Violation - CV Path p-parity
• T-ESL – Threshold Violation - Errored seconds line
• T-ESP-P – Threshold Violation - Errored seconds path p-parity
• T-LOSS-L – Threshold Violation - Loss of signal seconds line
• T-SESL – Threshold Violation - Severely errored seconds line
• T-SESCP-P – Threshold Violation - Severely errored seconds path
• WKSWPR – Working Unit Switched to Protect Unit
• WKSWBK – Working Unit Switched Back to Working
ctag Correlation Tag (optional)
dirn Direction
• RCV – receive
• TX – transmit
July 2004
TL1 Commands and Messages
TL1 Command List
9-57