Carrier Access Wide Bank 28 DS3 User Manual page 236

CLI Commands and Messages
CLI Command List
Elapsed Sec
Valid Intervals
FE Elapsed Sec
FE Valid Intervals
IP
Name:
Purpose:
Security:
Syntax:
8-48
N/A
N/A
587
96
IP Configuration
Configure the IP address, gateway, mask, and trap receiver addresses.
Set - rw and above with basic security; secu with Security Upgrade
Show - ro and above
See Security on page 1-5
option.
ip [address|mask|gateway|nms1|nms2|nms3|
ppp ipaddr|route {ethernet|ppp addr}]
Field Description
ip Use the command by itself to see current settings
address Set Wide Bank primary Controller address
mask Set subnet mask for LAN
gateway Set IP address for the LAN gateway
nms1 Set Network Management System (NMS) #1 to receive SNMP Trap
notifications
nms2 Set NMS #2 to receive SNMP Trap notifications
nms3 Set NMS #3 to receive SNMP Trap notifications
ppp Set IP address or route to other end of PPP link
ipaddr IP address in the form xxx.xxx.xxx.xxx, where xxx is a number from
0 to 255
route Configure route for outbound IP traffic via Ethernet or PPP
ethernet Send outbound packets to the Ethernet port, except those destined for
the PPP link (based on value of "ip ppp ipadress"
ppp Send outbound packets to the C-bit PPP link using DS3 Path
Maintenance Data Link
addr PPP address in the form xxx.xxx.xxx.xxx, where xxx is a number
from 0 to 255
LCV Error Rate
P-Parity Error Rate
C-Parity Error Rate
FE C-Parity Err Rate
for an overview of basic security and the Security Upgrade
July 2004
N/A
N/A
N/A
0
Wide Bank 28 DS3 - Release 2.4