Pcie Riser Card Assembly And Adapter Replacement - Lenovo ThinkSystem SR860 Maintenance Manual

Watch the procedure. A video of the process is available:
• Youtube: https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku:
http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. Align the panel with the slot on operator panel tray assembly, and slide it in until it clicks into place.
Figure 91. Front operator panel installation
After installing operator panel tray assembly, complete the following steps:
1. Reinstall the operator panel tray assembly (see "Install the operator panel tray assembly" on page 93).

PCIe riser card assembly and adapter replacement

Use this procedure to remove or install the PCIe riser card assembly and the adapters.
Remove the PCIe riser card assembly
Use this procedure to remove the PCIe riser card assembly.
Before removing the PCIe riser card assembly:
1. Read the safety information and installation guidelines (see "Safety" on page iii and "Installation
Guidelines" on page 59).
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page 10).
3. If the server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see "Remove the top cover" on page 146).
5. Remove the PCIe expansion tray (see "Remove the PCIe expansion tray" on page 149).
6. Disconnect the USB 3.0 cable of operator panel tray assembly, and remove it vertically from the system
board.
.
Chapter 3 Hardware replacement procedures
97