Briggs & Stratton 2691184-00 Operator's Manual page 10

If the engine does not start after repeated attempts, go to
BRIGGSandSTRATTON.COM or contact an authorized
dealer.
5. After the engine starts, move the throttle control to half
speed. Warm up the engine by running it for at least 30
seconds.
6. Set the throttle control to the FAST position.
In the event of an emergency, the tractor / engine can be
immediately stopped by turning the ignition switch to STOP.
For normal shut down, refer to Stop the Tractor and Engine .
Stop the Tractor and Engine
1. Release the ground speed pedals (see Features and
Controls ) to return to the NEUTRAL position.
2. While still on the lawn, disengage the Power Take-Off (PTO)
switch, then wait for all moving parts to stop.
3. Move the throttle control to the SLOW position.
4. Turn the ignition key to STOP the engine.
5. Remove the ignition key and keep out of the reach of
children.
6. Engage the parking brake.
a. To engage the parking brake, fully depress the brake
pedal, pull UP on the parking brake control, and release
the brake pedal.
b. To disengage the parking brake, fully depress the brake
pedal, press DOWN on the parking brake control, and
release the brake pedal.
Mowing
DANGER
This machine is capable of amputating hands and feet, and
throwing objects. Failure to observe the following safety
instructions could result in serious injury or death.
• Only operate the machine in daylight hours or good artificial
light.
• Avoid holes, ruts, bumps, rocks, or other hidden hazards.
Uneven terrain can overturn the machine or cause operator
to lose their balance or footing.
• Do not direct discharge material toward anyone. Avoid
discharging material against a wall or obstruction as material
may ricochet back toward the operator.
• Stop the blade(s) when crossing gravel surface.
• Do not leave a running machine unattended. Always park
on level ground, disengage the attachment, set parking
brake, stop engine, and remove starter insert..
1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls.
2. Use the Height-of-Cut Switch (see Features and Controls )
to set the cutting height to the desired level.
3. Set the throttle control to the FAST position.
10
4. Engage the Power Take-Off (PTO) switch to activate the
mower blades.
5. Disengage the parking brake, then begin mowing.
6. Push the forward ground speed control pedal to travel
forward. Release the pedal to stop. The further down the
pedal is depressed the faster the tractor will travel.
7. When finished mowing, shut off the PTO.
8. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the engine.
WARNING
The engine will shut off if the reverse ground speed pedal is
depressed while the Power Take-Off (PTO) is on and the
Reverse Mowing Option has not been activated. The operator
should always turn the PTO off prior to driving across on roads,
paths, or any area that may be used by other vehicles. Sudden
loss of drive could create a hazard.
Reverse Mowing Option (RMO)
DANGER
Mowing in reverse can be hazardous to bystanders. Tragic
accidents can occur if the operator is not alert to the presence
of children. Children are often attracted to the machine and
the mowing activity. Never assume that children will remain
where you last saw them.
• Keep children out of the operating area and under the
watchful care of a responsible adult.
• Do not carry passengers, especially children, even with
the blade(s) shut off. Children can fall off and be seriously
injured or interfere with the safe machine operation.
Children who have been given rides in the past can
suddenly appear in the mowing area for another ride and
be run over or backed over by the machine.
• Do not mow in reverse unless absolutely necessary.
Always look down and behind before and while backing.
• If the machine mows in reverse without Reverse Mowing
Option activated, see an authorized dealer immediately.