Table of Contents
Advertisement
PN 88300150
$SPn
n = 0 or 1
T
&Tn
n = 4 or 5
#Tn
n = 0 or 1
Un
n = 0, 1, 2,
or 3
Vn
n = 0 or 1
#Vn
n = 0 or 1
W
&Wn
n = 0 or 1
Xn
n=0 thru 4
&Xn
n = o thru 2 *** &X0 Sync internal clocking.
#Xn
n = 0 or 1
Yn
n = 0 or 1
Z
,
in Dial
command
;
in Dial
command
!
in Dial
command
@
in Dial
command
+++AT<CR>
BREAK AT<CR>
4/3/01
&SF1 selects DSR independent.
*** $SP0 disables UUCP Spoofing
$SP1 enables UUCP Spoofing
Modem will tone-dial numbers following the T.
&T4 means Enable Response to Request for
Remote Digital Loopback.
*** &T5 means Disable Response to Request for
Remote Digital Loopback.
#T0 turns off Trellis Coded Modulation
*** #T1 turns on Trellis Coded Modulation
U0 places modem in Analog Loop Originate Test Mode.
U1 places modem in Analog Loop Answer Test Mode.
U2 places modem in Remote Digital Loopback Test Mode.
U3 places modem in Local Digital Loopback Test Mode.
V0 means Result Codes sent as (terse response).
*** V1 means Result Codes sent as words (verbose response).
#V0 enables V.32terbo.
*** #V1 disables V.32 terbo.
Wait for new dial-tone.
&W0 causes modem to store its parameters in non-volatile RAM, and
modem loads these for future sessions instead of reading factory ROM defaults,
unless &F command used.
*** &W1 causes modem to not store parameters.
Xo selects Basic Result w/o CONNECT 1200, CONNECT 2400)
X1 selects Extended Result (w/ CONNECT 1200, CONNECT 2400)
X2 selects Standard AT command set NO DIAL TONE
X3 selects Standard AT command set with BUSY
*** X4 selects Standard AT command set with NO DIAL TONE and BUSY
&X1 Sync external clocking.
&X2 Sync slave clocking.
#X0 causes one XOFF to be sent until buffer reaches XON level
#X1 causes one XOFF to be sent for every character received after modem reaches
buffer full level
*** Y0 disables sending or responding to long space "break".
Y1 enables sending or responding to long space "breaks".
All configuration parameters are reset to default values.
Causes pause during dialing.
Causes return to Command Mode after dialing.
Causes modem to Flash On-Hook.
Causes modem to wait for ringback, then 5 seconds of silence before processing
next part of command.
Escape Code. Puts modem in Command Mode while remaining On-Line. Type +++
followed by the letters A and T & up to ten command characters, and hit ENTER.
Alternate Escape Sequence. Brings modem into Command mode while remaining On-
Line. Not preceded by AT. Type BREAK signal, followed by the letters A and T, up to
60 command characters, and hit ENTER.
85
Advertisement
Table of Contents
