Multitech MT2834MR Owner's Manual page 68

PN 88300150
Switch #4
AS/400 Mode
(Synchronous Mode/Leased Line/Dial-Up)
The MT2834MR can function in an IBM AS/400 environment. Place DIP-Switch #4 in the DOWN position
to cause the MT2834MR to operate via IBM command set.
Place DIP-Switch #4 in the UP position to disable AS/400 mode
Note: The MT2834MR must be in Command mode to allow AS/400 mode operation).
AS/400 Mode Enabled
AS/400 Mode Disabled
(Factory Default Setting = UP)
Switch #4
UNIX UUCP Spoofing
(Asynchronous Mode/Leased Line/Dial-Up)
The MT2834MR can be used with UNIX equipment which employs ACK flow control to monitor data
integrity. The MT2834MR can do UUCP "spoofing", where the modem is able to generate ACKs at the
DTE interface. Data is then transmitted more time-efficiently, because the delay of waiting for data to be
received then for the ACK to be returned at the remote end is eliminated. Place DIP-Switch #4 in the
DOWN position to enable UUCP spoofing.
UUCP Spoofing Enabled
UUCP Spoofing Disabled
(Factory Default Setting = UP)
Switch #5
Disable Auto-Answer - "Ans"
(Asynchronous Mode/Synchronous Mode/Dial-Up)
In some originate-only applications, you may wish to disable the MT2834MR's automatic answering
capabilities. This may be true if you have a telephone set attached to a modem and wish to receive voice
calls that you yourself would answer instead of the modem.
Auto-Answer Enabled
Auto-Answer Disabled
(Factory Default Setting = UP)
Switch #5
Originate/Answer Mode
(Asynchronous/Synchronous Mode/Leased Line)
The MT2834MR can function in either Originate mode or Answer mode. To enable Answer mode, place
DIP-Switch #5 in the UP position. To enable Originate mode, place DIP-Switch #5 in the DOWN position.
Origination Enabled
Answer Enabled
(Factory Default Setting = UP)
4/3/01
= Switch #4 DOWN
= Switch #4 UP
= Switch #4 DOWN
= Switch #4 UP
= Switch #5 UP
= Switch #5 DOWN
= Switch #5 DOWN
= Switch #5 UP
68