Table of Contents
Advertisement
PN 88300150
3.5
Result Codes
You can choose result codes that closely match those of the "Standard AT" command set ("Standard AT"
Responses) or enhanced function result codes that have been used in Multi-Tech modems in the past
("Multi-Tech responses"). The &Q command selects which result codes will be used.
The Command mode provides you with several responses, or "Result Codes," that can aid you in
Command mode operation. These Result Codes are displayed on your monitor or printout.
You can choose to have these Result Codes displayed in a "verbose" format (complete words), or in a
"terse" format (single digit numbers). The factory default setting is for the verbose format. To change this
setting to the terse format, use the V command.
You can also choose basic result codes (connect with no speed indication), extended result codes (with
speed indication), and whether you want call progress indications (busy and no dial tone) added to the
extended result code set. This is controlled with the X command.
CODE
OK
Your command was executed, and the MT2834MR is ready for your next command.
CONNECT
A carrier signal was detected at 300 bps.*
RING
A ring signal was detected from an incoming call.
NO CARRIER
No carrier signal was detected, or the carrier signal was lost.
ERROR
An error is present in your command sequence, (e.g., invalid character or too many
characters).
CONNECT 1200
A carrier signal was detected at 1200 bps.*
NO DIALTONE**
No dial tone was detected, and your modem will not dial.**
BUSY**
A busy signal at the number you dialed was detected.**
NO ANSWER
The Remote system did not answer.
CONNECT 2400**
A carrier signal was detected at 2400 bps.*
CONNECT 4800
A carrier signal was detected at 4800 bps.*
CONNECT 9600
A carrier signal was detected at 9600 bps.*
CONNECT 14400
A carrier signal was detected at 14,400 bps.*
CONNECT 19200
A carrier signal was detected at 19,200 bps.*
CONNECT 21600
A carrier signal was detected at 21,600 bps.*
CONNECT 24000
A carrier signal was detected at 24,000 bps.*
CONNECT 26400
A carrier signal was detected at 26,400 bps.*
CONNECT 28800
A carrier signal was detected at 28,800 bps.*
CONNECT 31200
A carrier signal was detected at 31,200 bps.*
CONNECT 33600
A carrier signal was detected at 33,600 bps.*
CONNECT 1275
The modem is connected in V.23 mode.
*
These responses are used only in the Extended Result Code set, and the CONNECT response will indicate a bps connection.
When the Basic Result Code set is used, the CONNECT response can be any speed from 2400 through 33,600 bps. A
connection using error correction will be indicated by the addition of the word LAP-M or RELIABLE (verbose) or the letter L or R
(terse) to the CONNECT responses. A connection using MNP5 data compression will be indicated by the addition of the word
COMPRESSED (verbose) or the letter C (terse) to the CONNECT responses.
** In the modem's default setting of blind dialing, these responses will not be used.
4/3/01
MT2834MR RESULT CODES
DESCRIPTION
21
Advertisement
Table of Contents
