Table of Contents
Advertisement
PN 88300150
7.1
Introduction
There are 3 sets of DIP-Switches and 3 two-position jumpers on the MT2834MR card. To remove the
MT2834MR modem card from the CC4800 rack, pull the ejector levers away from the rack (if necessary
loosen the retaining screw first), then carefully slide the modem card out of the rack.
The DIP-Switches are used to enable or disable various user-selectable options. Each DIP-Switch is set
to a factory default setting that is useful in most applications. Each set of DIP-Switches is labeled with a
number and can be set to either the UP (marked "OPEN") or Down position. The individual switches can
easily be set with your fingernail or a pencil tip.
Note:
Before changing any DIP-Switches on the MT2834MR, please consult your MultiCommManager
software manual. Many of these options can be controlled by the software.
Each of the 3-pin (two-position) jumpers is used to select options. They are also pre-set to factory default
settings that should be effective for your application. The default setting can be easily changed to an
option setting by removing the shorting plug and replacing in the option position.
The following sections detail the function of each DIP-Switch and jumper located on the MT2834MR PC
board.
4/3/01
Figure 7-1. Location of PC Board Controls
65
Advertisement
Table of Contents
