Front-Facing Imager Assembly - Lenovo motorola Moto Z Droid Service And Repair Manual

Moto Z (Droid) / Moto Z
Level 2 – Service and Repair Manual

Front-Facing Imager Assembly

Description
ASSY,PWA,MN,BD KIT, SHERIDAN,ROW
ASSY,PWA,MN,BD KIT, SHERIDAN, VZW,64GB
ASSY,PWA,MN,BD KIT, SHERIDAN,ROW, 64GB
ASSY,PWA,MN,BD KIT,SHERIDAN,CHINA
ASSY,PWA,MN,BD KIT, SHERIDAN-64GB,ROW (JAG)
ASSY,PWA,MN,BD KIT, SHERIDAN, 32GB-NA
ASSY,CAMR,5MP,FRONT IMGR
DIE CUT,TAPE,KAPTON,FRONT IMGR FLX
1. Remove the protective liner from the Front-
Facing Imager, if present.
2. Place the PCB on a flat, steady surface, as
shown.
3. Verify the Front-Facing Imager ZIF Connector
Door is open.
4. Insert the Front-Facing Imager Flex into the
Front-Facing Imager Flex ZIF Connector.
5. Slide a fingertip across the ZIF Connector Door
to close it.
6. Place Kapton tape over the Front-Facing Imager
ZIF Connector Flex.
PAGE 82
Reference #
2
28
--
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola