Fingerprint Sensor Assembly - Lenovo motorola Moto Z Droid Service And Repair Manual

Moto Z (Droid) / Moto Z
Level 2 – Service and Repair Manual

Fingerprint Sensor Assembly

Description
ASSY,LENS/DISPLAY, BLK, PRODN
ASSY,LENS/DISPLAY, WHT, PRODN
ASSY,FLXCKT,FPCB FPS,FINE GOLD, SHERIDAN
ASSY,FLXCKT,FPCB FPS,BLACK,ADDISON
ASSY,FLXCKT,FPCB FPS,LUNAR GRAY,SHERIDAN
DIE CUT,ADHES,KAPTON TAPE, COMP PROT (FPS ZIFF), SHERIDAN
DIE CUT,TAPE, REAR ANTI ROTATION, SHERID
1. Use cotton swabs and ISP Alcohol to clean the
FPS bonding surface. The FPS bonding surface
is highlighted in the photo.
// CAUTION //
FPS bonding surface cleaning is critical to the
phone's water resistance. You must thoroughly
clean the bonding surface with ISP Alcohol and
allow it to dry completely before applying
3M AP-111 Adhesion Promoter.
2. Wait for the ISP Alcohol to dry.
// CAUTION //
Do not use the same cotton swabs to clean with
ISP Alcohol and apply 3M AP-111 Adhesion
Promoter. The FPS will not properly adhere to the
Display if the cotton swabs are reused. The cotton
swabs may be used for 2 applications of the same
chemical, but then must be discarded.
3. Use cotton swabs to apply 3M AP-111 Adhesion
Promoter to the FPS bonding surface.
4. Wait for the 3M AP-111 Adhesion Promoter to
dry.
5. Remove the adhesive liner from the FPS.
6. Place the FPS on the Display, with the FPS Flex
oriented as shown. Align the FPS to the hole in
the bottom of the Display.
PAGE 116
Reference #
1
6
16 (qty 2)
--
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola