Moto Z (Droid) / Moto Z
Level 2 – Service and Repair Manual
Top Carrier Removal
NOTE
The Top Carrier can be recovered
and reused after removal.
1.
Use the Torque Driver and 3IP Torx Bit to
remove the 2 3IP Machine Screws from the Top
Carrier.
NOTE
After you remove the 3IP Machine
Screws, you cannot reuse them.
2.
Insert the Thin Plastic Spudger under the lower
left corner of the Top Carrier as shown.
3.
Slide the Thin Plastic Spudger to the right to
release the snap.
4.
If needed, use the Thin Plastic Spudger to
release the snap at the top of the Top Carrier.
5.
Lift the Top Carrier away from the Housing.
PAGE 35
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola