Rear-Facing Imager Bezel Removal And Assembly - Lenovo motorola Moto Z Droid Service And Repair Manual

Moto Z (Droid) / Moto Z
Level 2 – Service and Repair Manual

Rear-Facing Imager Bezel Removal and Assembly

Rear-Facing Imager Bezel Removal
NOTE
The Rear-Facing Imager Bezel must be replaced
immediately after removal. Failure to replace the
Bezel after removal may result in damage to the
Rear-Facing Imager.
NOTE
The Rear-Facing Imager Bezel can be
recovered and reused after removal.
1. Use the Torque Driver and 3IP Torx Bit to
remove the 4 3IP Machine Screws from the
Housing.
NOTE
After you remove the 3IP Machine
Screws, you cannot reuse them.
2. Use the pointed end of the Blackstick to push the
Rear-Facing Imager Bezel from the Housing.
// CAUTION //
Use caution when removing the Rear-Facing
Imager Bezel. Do not push on the Rear-Facing
Imager Lens or the Lens may shatter. Push on the
Proximity Lens portion of the Bezel.
NOTE
Do not attempt to remove the Rear-
Facing Imager Lens. The Lens cannot be
reused.
If the Lens is defective or damaged, see Rear-
Facing Imager Lens Assembly on page 130.
PAGE 54
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola