Table of Contents
Advertisement
Moto Z Play (Droid) / Moto Z Play
Level 2 – Service and Repair Manual
Fingerprint Sensor Assembly
Description
ASSY,HSG,LENS/DISPLAY,BLACK,PRODUCTION,2.5D,ADDISON
ASSY,HSG,LENS/DISPLAY,WHITE,PRODUCTION,2.5D,ADDISON
ASSY,FLXCKT,FINGER PRINT SENSOR,BLACK,O-FILM,ADDISON
ASSY,FLXCKT,FINGER PRINT SENSOR,ADDISON
ASSY,FLXCKT,FINGER PRINT SENSOR,WHITE,O-FILM,ADDISON
ASSY,FLXCKT,FINGER PRINT SENSOR,WHITE,CRUCIALTEC,ADDISON
DIE CUT,KAPTON TAPE,FPS
1.
Use cotton swabs and ISP Alcohol to clean the
FPS bonding surface. The FPS bonding surface
is highlighted in the photo.
// CAUTION //
FPS bonding surface cleaning is critical to the
phone's water resistance. You must thoroughly
clean the bonding surface with ISP Alcohol and
allow it to dry completely before applying
3M AP-111 Adhesion Promoter.
2.
Wait for the ISP Alcohol to dry.
// CAUTION //
Do not use the same cotton swabs to clean with
ISP Alcohol and apply 3M AP-111 Adhesion
Promoter. The FPS will not properly adhere to the
Display if the cotton swabs are reused. The cotton
swabs may be used for 2 applications of the same
chemical, but then must be discarded.
3.
Use clean cotton swabs to apply 3M AP-111
Adhesion Promoter to the FPS bonding surface.
4.
Wait for the 3M AP-111 Adhesion Promoter to
dry.
5.
Place the Display into the Addison Display
Assembly and Press Fixture (3-00-K7-10000),
with the Display side down.
PAGE 107
Reference #
1
6
--
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
