Moto E5 Play
Level 2 – Service and Repair Manual
Fingerprint Sensor Removal
NOTE
The Fingerprint Sensor (FPS) can be
recovered and reused after removal.
1.
Use the Thin Plastic Spudger to disengage
the FPS BtB Connector from the Main PCB.
2.
Use the flat end of the Blackstick to loosen the
FPS from the Main PCB.
3.
Lift the FPS from the Main PCB.
4.
Use the Thin Plastic Spudger to pry the FPS
Holder from the back of the FPS.
//CAUTION//
Use care not to damage the FPS.
5.
Use the Tweezers to remove the FPS
Conductive Foam from the Main PCB.
NOTE
After you remove the FPS Conductive
Foam, you cannot reuse it.
PAGE 27
Lenovo Confidential Restricted:
Do not share without consent from Lenovo