Multitech MA6 Quick Start Manual page 49

Canadian Limitations Notice
Notice: The ringer equivalence number (REN) assigned to each terminal device provides an
indication of the maximum number of terminals allowed to be connected to a telephone
interface. The termination of a interface may consist of any combination of devices subject
only to the requirement that the sum of the ringer equivalence numbers of all the devices
does not exceed 5.
Notice: The Industry Canada label identifies certificated equipment. This certification means
that the equipment meets certain telecommunications network protective, operational and
safety requirements. The Industry Canada does not guarantee the equipment will operate to
the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company. The equipment must also be installed
using an acceptable method of connection. The customer should be aware that compliance
with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
Compliance with BABT Requirements
Approved for connection to telecommunications system specified in the instructions for use subject to
the conditions set out in them.
Warning: Interconnection directly, or by way of other apparatus, of ports marked "SAFETY
WARNING see instructions for use" with ports marked or not so marked may produce hazardous
conditions on the network. Advice should be obtained from a competent engineer before such a
connection is made.
MA6
Manufacturer:
Model Number:
FCC registration number:
Ringer Equivalence No:
Service Center in USA:
Multi-Tech Systems, Inc.
ISI3334/4, ISI3334/EC and ISI3334/8
AU7USA-23834-MM-E
0.3B
Modular Jack (USOC)
RJ11C or RJ11W (single line)
Multi-Tech Systems Inc.
2205 Woodale Drive
Mounds View, MN 55112
Voice (763) 785-3500/
FAX (763) 785-9874
49