Table of Contents
Advertisement
4
Remove the screw that secures the SBC board to the chassis at the back of the
MiniArray
5
Remove the SBC board from the midplane.
6
To replace the SBC board, verify SBC board configuration; refer to the Hardware
Configuration and Installation instructions in the SBC manual.
7
Install the new SBC board by following steps 1-5 in reverse.
8
If other boards are being installed, perform those procedures below now, and then
remount the MiniArray
Step
Procedure
Removing NIC Board
1
Remove the MiniArray
2
Remove the top cover from the MiniArray
3
Remove the screw that secures the NIC board to the chassis at the back of the
MiniArray
4
Remove the NIC board from the midplane.
5
To replace the NIC board, verify NIC configuration; refer to the Installation
Instructions in the appropriate NIC section of this manual.
6
Install the new NIC board by following steps 1-4 in reverse.
7
If other cards are being installed, perform those procedures below now, and then
remount the MiniArray
Removing ISI Boards
1
Remove the MiniArray
2
Remove the top cover from the MiniArray
screws located in the back of the MiniArray
3
Remove the chasis mounting screw from the card cage. See figure 4-4.
28
III
.
III
in the enclosure. See Step 6 of Table 4.1.
Table 4.3Board Removal/Replacement Procedure (cont'd.)
III
from rack enclosure following the procedures in Table 4.1.
screws located in the back of the MiniArray
III
.
III
in the enclosure. See Step 6 of Table 4.1.
If removing or replacing the single ISI board on the
left side (looking from the front) of the midplane, no card cage removal is
necessary. Ignore steps 3 through 5.
III
from rack enclosure following the procedures in Table 4.1.
III
by removing the seven cover mounting
III
. See figure 4-3.
Note
III
by removing the seven cover mounting
III
. See figure 4-3.
MA6
Advertisement
Table of Contents
