Table of Contents
Advertisement
4
Being careful to maintain slack in the power cables, lift the card cage up and over so
that it can rest along side the chassis.
5
Remove the screw(s) that secures the ISI board(s) to the chasis at the back of the
MiniArray
6
Remove the ISI board(s) from the midplane.
7
To replace the ISI board(s), verify ISI board configuration; refer to the Installation
Instructions in the ISI section of this manual.
8
Install the new ISI card(s) by following steps 1-6 in reverse.
Hard Disk Drive Removal/Replacement
Step
Procedure
1
Remove the MiniArray
2
Remove the top cover from the MiniArray
screws located in the back of the MiniArray
3
Disconnect the power and data cables from the back of the hard disk drive.
4
Remove the two screws securing the hard drive to the drive chassis.
5
Remove hard drive by sliding it off of the drive chassis, towards the back of the unit.
6
To install a new hard drive, follow steps 1-5 in reverse.
Floppy Disk Drive Removal/Replacement
Step
Procedure
1
Remove the MiniArray
2
Remove the top cover from the MiniArray
screws located in the back of the MiniArray
3
Remove the chassis mounting screw from the card cage. See figure 4-4.
4
Being careful to maintain slack in the power cables, lift the card cage, including fan
housing, up and over so that it can rest along side the chassis.
MA6
III
.
Table 4.4 Hard Drive Removal/Replacement Procedure
III
from rack enclosure following the procedures in Table 4.1.
If you are simply adding a hard drive and not replacing the
existing hard drive, proceed to step 6.
Table 4.5 Floppy Drive Removal/Replacement Procedure
III
from rack enclosure following the steps in Table 4.1.
III
by removing the seven cover mounting
III
. See figure 4-3.
Note
III
by removing the seven cover mounting
III
. See figure 4-3.
29
Advertisement
Table of Contents
