Isi Board Cabling; Nic Cabling - Multitech MA6 Quick Start Manual

ISI Board Cabling

Each ISI3334/8 board takes up one physical slot in the MiniArray
configuration, you may have a total of up to four (4) cards (see figure 2-1). Attach the RJ11
line cords to the RJ11 line connectors on the ISI card(s) at the back of your MiniArray
shown in Figure 2-3.

NIC Cabling

The EN-series EtherNet NIC is located as shown in Figure 2-4. The NIC connectors are of
theUTP (RJ45 connector) type.
Connect the appropriate network cable to the NIC in the MiniArray
connectors are shown and defined in Appendix A.
MA6
Fig. 2-3. ISI Board Connectors
Note
Any cables connected to the MiniArray
be shielded to reduce interference.
Fig. 2-4. NIC Board Connector
Note
Any cables connected to the MiniArray
be shielded to reduce interference.
III
. Depending on your
•
[( )]
III
should
III
. The various NIC
III
should
III , as
15