Multitech MA6 Quick Start Manual page 35

• Verify that SBC and adapter boards are seated properly in ISA slot. NOTE:
• Hard drive or floppy drive cables are not connected properly or parameters
• Verify that enough memory is installed to load the intended applications.
• Verify that two or four 72-pin SIMMs are seated properly on the SBC. The
• If some device other than a modem is connected to COM1, verify that the
• Remove all adapter cards. If system boots there is a conflict with an adapter
• If problem persists, contact MultiTech's Technical Support Department, refer
• COM1, COM2 or LPT1 port does not respond correctly
• If some device other than a modem is connected to COM1, verify that the
• Try COM2, if it also fails, check Setup configuration and verify that the ports
• Check if any adapter boards are conflicting with ports. If ports are used by
• Check that cables are connected properly and peripherals are powered ON
• If problem persists, contact MultiTech's Technical Support Department, refer
• Keyboard does not respond to key strokes
• Connect keyboard cable to the left round connector on SBC.
• If cable converter is used to connect a large 5-pin DIN to a small 6-PIN PS/2
• Verify that the keyboard works on a different system.
• If problem persists, contact MultiTech's Technical Support Department, refer
• Invalid Time, Date or Setup
• Battery is failing.
• Last system boot was incomplete. Verify in Setup that configuration is
• If problem persists, contact MultiTech's Technical Support Department, refer
MA6
Make sure to turn power off to reconnect boards.
are not set properly in setup.
SIMMs must be the same brand, size and speed.
DCD jumper is not installed.
card.
to Chapter 6 of this manual.
DCD jumper is not installed.
are enabled.
an expansion card, then on board ports must be turned off in Setup.
and configured properly.
to Chapter 6 of this manual.
DIN, this converter could be bad or of the wrong type.
to Chapter 6 of this manual.
correct and reboot system.
to Chapter 6 of this manual.
35