Table of Contents
Advertisement
2
Remove the top cover from the MiniArray
screws located in the back of the MiniArray
3
Remove the chassis mounting screw from the card cage. See figure 4-4.
4
Partially remove the card cage and remove power cabling at midplane.
5
Remove power cables from the back of hard drive, floppy drive, and CD ROM drive.
6
Remove the three power supply mounting screws from the back of the MiniArray
7
Remove the power supply from the chassis.
8
To install a new power supply, follow steps 1-7 in reverse.
MA6
III
by removing the seven cover mounting
III
. See figure 4-3.
III
.
31
Advertisement
Table of Contents
